Guitar Learning Guide For Beginners - Reading Tablatur

Want to become as good guitarist Paul Gilbert or Steve Vai?? certainly not easy to become a guitar god, even more so if you do not have a basic and primary base guitar. therefore for the opportunity this time I'll write some basic guidelines in playing guitar.

All the beginners course to learn basic guitar basic, starting from the correct way of tuning, strumming techniques, technique palm mute, until the advanced engineering techniques such as arpeggios, tapping, sweeping up the alternate picking.

Before beginning this guide further recommended that you learn to read music, or at least tabulation (tablature) tablature serves to read the tone of the press note on the guitar fret .. as an example:



-------------- E
-------------- B
-------------- G
-------------- D
-------------- A
-------------- E

The top E string at the bottom means that the guitar strings, aka 1. and B means the strings 2, G means the strings and so on .. 3 E, B, G, D, A, E is the steman standard guitar tone in a state of open fret ..

If the tablatur written as follows:

-------- 9 --- E
------ 6 ----- B
---------- 10G
------------ D
------------ A
------------ E

This means that should you hit first is the string 2 fret 6, then string 1 fret 3rd string 9th fret and then 10.

Usually within a few tablatur reading symbols such as Ho, Po, T, ~ ~ as well as PM, that is:

Ho: This indicates Hammer On. you must press the first note and then immediately move to the next note without picking .. example

---- 3 - (Ho) 5 ------- E

you have to press the string 1 fret 3 first and then the 5th fret pressed directly with another finger without picking the string ..

Po: This means Pull Off. the opposite of hammer on, so you must pick the first note and then immediately moved to fret behind it (removed) without picking again ..

PM: Palm Mute This means that you must play your guitar without the sound management. in particular by reducing your guitar sound (usually string string bass) with your hand side .. Consider Figure



Q: Tapping .. you do this technique without plucking the string but the string was touched .. this example ..

----- 2 --- 5 ---- T11 - E

First you press 2 and then senar1 fret 5th fret with another finger then your right hand used to press the 11th fret it .. Tapping has many variations .. if you can combine them with the hammer on and pull off ..

~ ~: This means a vibrato or vibration .. you should make the strings sound like strings vibrate by pressing firmly and then lifting slightly down again over and over again ..

Well so used to reading from me .. tablatur I'll see you on the issue of other guitar lessons

source : http://varius-opinion.blogspot.com/2009/07/panduan-belajar-gitar-untuk-pemula.html